I lofted the transom but this transom's lofting was bit difference with the lofting I have done before.I realized that the transom's sickness combined the plywood and fashion piece.Under Merf's help I figured out the plywood with 6mm sickness and the fashion piece with 20mm.
Well although I don't need to loft them out but I have to know where are they and how will they fix together.
This would be a good way to cut it out
( Below )
This is the cutting list of the fashion piece of transom.
I used AutoCAD to lay it out that would be easy to understand.
Ok,it's time for transferring the transom onto the plywood of 6mm.
I need :
small batten
steel rule
pencil and rubber
nils and hammer
Attention :
the ratio of the camber is 1:12.4 (from ACAD)
the scale 1:4
the distance between edge of the board and drawing is 10mm.
after drawing I will cut it out by band saw and plane the edges.
No comments:
Post a Comment